Make the Holes Into Squares
Repairing holes in your repair sheetrock begins by making the hole a little bigger. While this might seem counterintuitive, it is important to remember that straight lines are much easier to work with than rounded and irregularly shaped holes. Cut the hole into square, measure the space, and then cut a piece of scrap sheetrock to match the now easily defined measurements.
Replace the Hole
Now that your replacement piece is cut, it can be placed in the hole and drilled into place. Mesh tape should be added all around the edge for added stability. This material is easy to work with, and does a lot to make the work easier and is worth doing.
Apply the Setting Compound You need to choose a setting compound that easily matches the level and texture of the wall around the hole. It takes two or more coats. Make sure that each coat is completely dry before adding another one. Sand the compound down when it has reached the desired thickness. The sanding helps it to match the texture of the surrounding wall.
Prime and Paint
When you are happy with the texture of the repaired section, you are ready to prime and paint the area. If you are merely patching, then the priming and painting only needs to be done on that spot. If the whole wall is being painted, then the section with the repaired sheetrock can be done with the rest of the wall.
0 Comments